Live share grundig forum 720p#
Live share grundig forum tv#

We played a number of MKV and MP4 files at 1080p and 720p resolution on the Grundig Meglio to give it a test run. Any casual viewer will be happy with the Grundig Meglio GLED2211HDV for watching TV, DVD or most Blu-ray movies. We watched The Dark Knight and Terminator: Salvation to determine the screen's contrast performance at default settings the screen tends to wash out highlights a little but lowering brightness meant we could see a reasonable amount of detail in both dark and bright areas. In ideal viewing conditions the Meglio is able to display a good level of detail, similar to the (although at a slightly smaller screen size).

The whole was covered with a hot glue to reinforce it.If you have the Grundig Meglio TV at or near eye level, this won't be an issue. When you find the proper pins, they should be cut off from the circuits that adapt them for the head and through electrolytic capacitors 1uF they should be connected with the signal of module. Its catalog sheet says that the signal from the cassette enters the 35 and 36 pin. The radio is based on preamplifier TDA7340. AGND was connected only on one side, to prevent from ground coupling. In order to do that, you should use a shielded cable. After simulation of its presence in the radio, the module is turned on.Īnother thing to do is to connect audio signal.

Module power was connected normally instead of cassette drive motor. When all that is done, you can start connecting the electronics. It was done just in case to insulate the board and limit possible vibrations or other sounds in rigid housing. A non-conductive foam tape 2-sided adhesive was placed between the additional plates and the board. The module has no assembly holes, so that the presented method is the only method of assembly. Then, using aluminum plate and screws M3, you can make a fastening for the plate of MP3 module. In order to fit the MP3 module, you have to expand the cassette hole in metal frame of radio. The filter fits closely and additionally it is stuck using glue Distal.

The red plexiglass looks far better when its dark. It would be better to use a grey smoky filter because the red one spoils the color of the entire radio in the sunlight. After removing the cassette flap, a filter for display with holes for the USB connector and SD card was made of red plexiglass. For this reason, a 2-pole rocker switch was used. In practice, it is the short circuit of two cables for constant, then shorting them with one cable in parallel with another pair. For radio AD182, it is necessary to simulate three switches so that the radio detects a cassette inside and A side is played, and the head of the radio is down. In described here radio, it is impossible to switch to tuner when the cassette is still inside, so that you have to emule its insertion and behavior of the drive. To make it properly, start with examining the operation of your radio and learn to turn on the cassette mode. To modify the radio, you have to remove the cassette mechanism firstly. This module can be handled only using the remote control.

The device uses only the holes for the cassette and buttons for auto reverse handling. In order to make an aesthetic construction, there were no buttons in the radio housing. The module can be controlled using buttons or attached mini IR remote control. It is equipped with radio tuner (which is not used in this case), linear input and output for the preamplifier. The circuit is powered from 12V (uses a stabilizer 5V placed on the board). Display and card/pendrive input are in the place where a cassette was inserted once. It consists of inserting a module that plays MP3 into the radio. It is a modification of factory radio Grunding AD182M.

Live share grundig forum 720p#

Live share grundig forum tv#